Crassula ‘Hobbit’ (Crassula ovata)

Add to My Plants (1)
Close

No account yet? Register

Plant Details

Category: Houseplants
Light: Bright Light
Bloom Season:
Height: 6-12" / 
15-30cm
Space: 12" / 
30cm
Zones: 11, 12
Lowest Temp: 40° to 80°F / 
4°C
Colors:

Basic Care

Does best in light, well-drained soil. Allow soil to dry between thorough waterings. Apply a balanced liquid fertilizer monthly during active growth. In winter months, water sparsely, only enough to keep leaves from wilting. Rotate plants often to maintain uniform growth.

Water

Allow soil to dry between thorough waterings.

Soil

Prefers fertile, sharply drained soil.

Feed

Once every month during growing season.

Slow Growth

Containers

hedges

Hedges

Features

Like all jade plants, the ‘Hobbit’ Jade is an easy-to-care for succulent that is considered by many, not only perfect to brighten your interior, but also likely to bring your household good luck. This unusual jade plant has tubular leaves that are very similar to Crassula ovata ‘Gollum’ with reddish tips, however ‘Hobbit’ leaves curl back, appearing as more of a spoon shape. The ‘Hobbit’ and ‘Gollum’ Jades are part of the Tokien Group – Crassula named after the fictitious characters in J.R.R. Tolkein’s books.

Uses

Perfect for all kinds of containers. Unique leaf shapes give these succulents a modern, sculptural appeal. Likes lots of sunlight. A south or west-facing window is ideal. Potted plants can be grown outdoors in the summer and brought back inside when temperatures are expected to fall below 50°F (10°C). Can be grown outdoors year-round in frost-free climates, in a pot or in the ground.

Crassula ‘Hobbit’ (Crassula ovata) Care Guide

Start with a good quality, commercial potting soil for Cacti and Succulents. That will ensure that the soil is sterile and pest-free. Many are available with a mild starter fertilizer in the mix. If you choose to make your own soil mix, combine equal parts sand and general purpose potting soil.

Select a container with a drainage hole or be prepared to drill holes for drainage if there are none.

Prepare the container by filling with potting soil up to 2” (5cm) from the rim of the planter. Make a hole in the center of the soil large enough to hold the root ball of the plant.

Remove the plant from its pot. Place it in the planting hole and press soil firmly around the roots, just covering the root ball. For spiny plants, use a stick, spatula, or other utensil to move the soil and to keep distance between your hands and the spines.

Repot every 2 years. Unless the roots are pot-bound the same container can be used. If a larger pot is needed choose one not more than 1-2” (3-5cm) larger in diameter than the existing pot.

Apply water at the soil level if possible to avoid wetting the plant. Water the entire soil area until water runs out the base of the pot. This indicates that the soil is thoroughly wet. Discard any excess water that has accumulated in the pot’s saucer.

Don’t water again until the top 1-2” (3-5cm) of soil is completely dry. Check the soil moisture with your finger. Plant may require less water during the winter months when it’s growing more slowly because of lower light levels. Some species may even go dormant for a few months in winter.

Cactus and succulent plants can be pruned to remove dead or damaged parts or to maintain a specific size or shape. Pruning encourages new growth, branching, and provides plant pieces that can be used for propagating more plants. Keeping the plant trimmed also encourages more side-shoots and reduces the demand for the plant to develop a larger root system. This is important since the roots are in a confined space.

Depending on the growth habit of the plant: long succulent leaves can be cut back to the base of the plant. Side stems can be cut back to the main trunk. If trimming to shape, cut off smaller segments just above a joint.

Baby cacti that grow on the main plant are known as “pups”. They can get very thick on some types of cacti. Pups can be cut off with a sharp knife at a 45-degree angle. Allow the cut area on the pups to air dry until a callous forms and they can be set in moist sand to root and eventually form new plants.

Some cacti and succulents produce “offsets”. These are plants that grow next to the mother plant by short rhizomes. These can be cut off at the rhizome and used to start new plants just like pups.

Fertilizers are available in many forms: granulated, slow-release, liquid feeds, organic or synthetic. Determine which application method is best for the situation and select a product with a nutritional balance designed for cactus and succulent plants.

Too much fertilizer can damage plants so it’s important to follow the package directions to determine how much, and how often, to feed plants.

Slow-release fertilizers are an especially good, care-free choice for container plants. A single application can often provide plants with the proper level of nutrition all season long.

A general-purpose fertilizer for house plants can be used for feeding cacti or succulents but it must be diluted to one quarter the strength of the normal rate.

Companion/Combination Plants

0 Comments

Submit a Comment

Your email address will not be published. Required fields are marked *

Find more plants for your garden or home!

Pin It on Pinterest

Share This

Share this post with your friends!