Viola ‘ColorMax Series’ (Viola cornuta)

Add to My Plants (0)
Close

No account yet? Register

Plant Details

Category: Annual
Light: Sun to Part Shade
Bloom Season: Spring, Summer, Autumn
Height: 4-6" / 
10-15cm
Space: 8-10" / 
20-25cm
Zones: 5, 6, 7, 8, 9
Lowest Temp: -20° to -10°F / 
-29° to -23°C
Colors: Black

Basic Care

Grow in fertile, humus-rich, well-drained soil. Keep soil moist, watering freely in dry weather. Remove faded flowers. Apply a summer mulch to retain moisture.

Water

Keep soil evenly moist.

Soil

Fertile, humus-rich, well-drained soil.

Feed

Slow release feed in spring.

Ornamental Flower

Ornamental Foliage

Containers

dried flowers

Dried Flower

rock gardens

Rock Gardens

Beds

border plants

Borders

Features

One of the most vigorous, fast-growing, heat-tolerant Viola varieties available. The exceptionally large flowers look more like Pansies than Violas! Flower size may be smaller during the hottest part of summer but will increase again in the cooler temperatures of fall. The blooms make excellent pressed flowers for crafts or putting in a note or greeting card.

Uses

Perfectly sized for rock gardens and border fronts. Perfect for all kinds of containers. Especially nice for mixing with spring bulbs.

Viola ‘ColorMax Series’ (Viola cornuta) Care Guide

Prepare the garden by breaking up the existing soil (use a hoe, spade, or power tiller). Add organic matter such as manure, peat moss or garden compost until the soil is loose and easy to work. Organic ingredients improve drainage, add nutrients and encourage earthworms and other organisms that help keep soil healthy. Give plants an extra boost by adding a granulated starter fertilizer or a balanced all-purpose feed (for example fertilizers labeled 12-12-12).

Check the plant label for suggested spacing. Crowding plants can result in fewer blooms and weak growth as the plants compete for light. Exceptions to this might be regions with a short growing season, shade plantings which tend to grow slower and fill in less quickly, or a need to fill an area with color quickly such as for a special event or if planning to entertain guests outdoors.

Remove the plant from the container. If plants are in a pack, gently squeeze the outside of the individual plant cell while tipping container to the side. If plant doesn’t loosen, continue pressing on the outside of the container while gently grasping the base of the plant and tugging carefully so as not to crush or break the stem until the plant is released. If the plant is in a pot, brace the base of the plant, tip it sideways and tap the outside of the pot to loosen. Rotate the container and continue to tap, loosening the soil until the plant pulls smoothly from the pot.

Dig the hole up to two times larger than the root ball and deep enough that the plant will be at the same level in the ground as the soil level in the container. Grasping the plant at the top of the root ball, use your finger to lightly rake the roots apart. This is especially important if the roots are dense and have filled up the container. Set the plant in the hole.

Push the soil gently around the roots filling in empty space around the root ball. Firm the soil down around the plant by hand, tamping with the flat side of a small trowel, or even by pressing down on the soil by foot. The soil covering the planting hole should be even with the surrounding soil, or up to one inch higher than the top of the root ball. New plantings should be watered daily for a couple of weeks to get them well established.

Vining annuals require vertical space to grow, so provide a trellis, fence, wall or other structure that allows the plant to grow freely and spread.

Herbs are ideal for containers. Pots can be brought indoors for the winter and placed near a sunny window for a continuous harvest year-round.

Prepare the garden by breaking up the existing soil (use a hoe, spade, or power tiller) to a depth of 12-16” (30-40cm). Add organic matter such as manure, peat moss or garden compost until the soil is loose and easy to work. Organic ingredients improve drainage, add nutrients, and encourage earthworms and other organisms that help keep soil healthy.

Check the plant label for suggested spacing and the mature height of the plant. Position plants so that taller plants are in the center or background of the landscape design and shorter plants in the foreground. To remove the plant from the container, gently brace the base of the plant, tip it sideways and tap the outside of the pot to loosen. Rotate the container and continue to tap, loosening the soil until the plant pulls smoothly from the pot.

Dig the hole up to two times larger than the root ball and deep enough that the plant will be at the same level in the ground as the soil level in the container. Grasping the plant at the top of the root ball, use your finger to lightly rake apart the lower roots apart. This is especially important if the roots are dense and have filled up the container. Set the plant in the hole.

Push the soil gently around the roots filling in empty space around the root ball. Firm the soil down around the plant by hand, tamping with the flat side of a small trowel, or even by pressing down on the soil by foot. The soil covering the planting hole should be even with the surrounding soil, or up to one inch higher than the top of the root ball. New plantings should be watered daily for a couple of weeks to get them well established.

Finish up with a 2” (5cm) layer of mulch such as shredded bark or compost to make the garden look tidy, reduce weeds, and retain soil moisture.

New plantings should be watered daily for a couple of weeks. After that, depending on the weather and soil type, watering can be adjusted to every two or three days. Clay soils hold moisture longer than sandy soils, so expect to water more frequently in sandy settings.

Different plants have different water needs. Some plants prefer staying on the dry side, others like to be consistently moist. Refer to the plant label to check a plant’s specific requirements.

Ideally water should only be applied to the root zone – an area roughly 6-12” (15-30cm) from the base of the plant, not the entire plant. A soaker hose is a great investment for keeping plants healthy and reducing water lost through evaporation. Hand watering using a watering wand with a sprinkler head attached is also a good way to control watering. If the garden area is large, and a sprinkler is necessary, try to water in the morning so that plant foliage has time to dry through the day. Moist foliage encourages disease and mold that can weaken or damage plants.

To check for soil moisture use your finger or a small trowel to dig in and examine the soil. If the first 2-4” (5-10cm) of soil is dry, it is time to water.

Prune plants freely to maintain the desired size and shape. Pinching plants back stimulates dense, bushy new growth and encourages more flowers.

Remove old flowers to keep plant looking healthy and prevent seed production that drains the plant’s energy at the expense of forming new flowers.

Some plants are grown only for their attractive foliage (such as coleus, dusty miller and flowering kale). Their flowers are not very showy and any buds should be pinched off to keep the foliage looking its best.

Dead branches should be removed close to the trunk, flush with the bark. When pruning to control a plant’s size or shape, cuts should be made just above a leaf bud and at a slight angle. This bud will be where the new growth sprouts.

Many shrubs can be regularly sheared to keep them shaped as a hedge, edging or formal foundation planting.

Always use sharp, clean tools when pruning. There are many tools available depending on the job. Hand shears, pruners, and loppers are ideal for most shrubs. Pole pruners and tree saws are better for large, mature shrubs or trees. If a tree is so large that it can’t be safely pruned with a pole pruner, it is best to call in a professional tree service.

Fertilizers are available in many forms: granulated, slow-release, liquid feeds, organic or synthetic. Determine which application method is best for the situation and select a product with a nutritional balance designed to encourage blooming (such as 5-10-5).

Too much fertilizer can actually damage plants so it’s important to follow the package directions to determine how much, and how often, to feed plants.

Too much fertilizer can damage plants so it’s important to follow the package directions to determine how much, and how often, to feed plants.

Slow-release fertilizers are an especially good, care-free choice for container plants. A single application can often provide plants with the proper level of nutrition all season long.

A general-purpose fertilizer for house plants can be used for feeding cacti or succulents but it must be diluted to one quarter the strength of the normal rate.

Companion/Combination Plants

0 Comments

Submit a Comment

Your email address will not be published. Required fields are marked *

Find more plants for your garden or home!

Pin It on Pinterest

Share This

Share this post with your friends!